• Rss feeds articles
High Altitude Balloon ► Tags ► "balloon"

Fill Tube

14 09 2014   //   Written by Yannick   //   Classified in : HAB  //  Tags : balloon, cord, fillTube

I builded the fill tube folowing ideas of this UKHAS wiki page.

As I don’t have something to create a grove, I used a PVC waste water plug that already have some kind of grove by design.

  • I strongly glued the flexible fill on it.
  • To close the remaining space, I added some wet newspaper sheets to create a temporary “wall”.
  • I used a hot glue gun, and let the hot glue fall all around the both sides of the newspaper.
  • I drilled a small hole to attach a nylon cord to be used for weighting and to secure to the ground bebore launch.

I was very happy with it.
Looks strong and very easy to build.

Flight chain

26 04 2014   //   Written by Yannick   //   Classified in : HAB  //  Tags : payload, cord, parachute, balloon

Payload

The payload is made with foam, then protected with flashy orange tape for maximum visibility (in the air and on the ground).

A label explaining it is harmless, with contacts details is outside and inside the box.

The payload contain:

  • Raspberry Pi Model A
    • Some unused connectors have been removed (RCA..)
    • Running Raspbian
    • MicroSD 8GB
    • SD to microSD adapter
      to limit the risk of the regular SD to be moved away of the slot.
    • Additional capacitor (more details provided in a future post)
    • default 3.3V regulator (could be improved for a future flight)
  • USB Hub
  • 2 x Prolific PL2303 USB toSerial for Radio and GPS.
  • Raspberry onboard serial interface on GPIOs used for administrative tasks.
  • GPS UBLOX MAX-7Q
    • Can go over the 18 Km CoCom limit
    • Commands sent to enable the “Flight mode”
  • Radio Radiometrix NTX2 434.650 MHz
  • Homemade quater wave ground plane antenna
  • 3G USB Key Huawei K3565 used to send coordinates by SMS on the ground
  • Relay to control power of 3G/SMS USB Key (powered only after burst and under 2000m)
  • Sensors
  • Raspberry PI Camera - 5MP
  • Canon A590IS - 8MP
  • Battery Romoss 5V / 5200 mAh

Cord

  • Braided Nylon Cord 1mm
    Required by French Civil Aviation Authority / ICAO - Separation force limit 230 N

Parachute

Balloon